Communication With The Card Slot Failed" Is Displayed During Setup - Canon PIXMA MP600R Manual De Instrucciones

Ocultar thumbs Ver también para PIXMA MP600R:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 167
Problem
"Communication with the Card Slot
failed" is displayed during setup
Possible Cause and Measures
This message is displayed if installation of the network drive for the Card Slot
fails during setup.
(1)Retry
Click to retry the network setup of the Card Slot.
(2)Skip
Click to continue installation without the network setup of the Card Slot.
When this message is displayed, wait for a while, then click Retry. If it fails
again, follow the procedure below.
Make sure that the computer is communicating with the network properly,
then restart the computer. Then try again.
Disable the Windows Firewall function, or open port 137:139 to allow
communication with the machine following the procedure below. For
information on other security software, refer to its instruction manual or
contact its manufacturer.
Important
If you disabled the firewall function, disconnect your network from the Internet.
To do this, configure your access point or router not to connect to the Internet or
WAN.
To disable the Windows Firewall:
(1) Click Start > Control Panel > Security Center > Windows Firewall.
(2) Select Off and click OK.
To open port 137:139:
(1) Click Start > Control Panel > Security Center > Windows Firewall.
(2) Select the Advanced tab and select the target connection, and click
Settings.
(3) Select the Services tab, and click Add.
(4) On the Service Settings dialog box, input the following information, and
click OK.
Description of service: Input the name of this service.
Name or IP address: Input the IP address of the machine. For details,
see "Printing Out Network Setting Information" on page 75.
External Port number for this service: Input "137".
TCP/UDP: Select TCP.
Internal Port number for this service: Input the same number as
External Port number.
(5) Repeat step1 to 3. On the Service Settings dialog box, input the same
information as you did in step 4 except for selecting UDP in TCP/UDP.
(6) Use the same procedure to open the other ports (138TCP, 138UDP,
139TCP, and 139UDP).
(1)
(2)
Troubleshooting
71

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido