Swimming Profile; Setup; View Exercise Record During Swimming - Oregon Scientific SE900 Manual Del Usuario

SWIMMING PROFILE

SETUP

You can do swimming setup on the watch. In SWIMMING mode, press top (1) button to enter setup mode. The setup mainly includes the following parts:
• Swim type
Pool size
•
Calibration
•
NOTE Avoid pressing any buttons while in the water whatever you do settings or
swimming, as this may cause water to enter the watch, leading to malfunction.
Swim type setup
1. In SWIMMING mode, press top (1) button to enter setup mode.
2. Press middle (2) button to enter swim type mode, then press top (1) button or
press bottom (3) button to select from ft.crawl (front crawl), backstr (backstroke),
breastsr (breaststroke) and butterfly.
3. Press middle (2) button again to confirm selection.
Pool size setup
1. In SWIMMING mode, press top (1) button to enter setup mode.
2. Toggle middle (2) button to enter pool size mode, then press top (1) button or press bottom (3) button to select from 50m (meters) and 25m (meters).
3. Press middle (2) button again to confirm selection.
Calibration
1. In SWIMMING mode, press top (1) button to enter setup mode.
2. Toggle middle (2) button until start cali. displays.
3. Press top (1) button to start calibration.
OR
Press bottom (3) button to exit.
4. Lap counting data displays. You need to swim for 2 laps and manually press t (1) button to stop above the water surface. Once you successfully complete the calibration,
cali.done displays then after 2 seconds the screen goes back to setup screen.
OR
If you want to stop the calibration, press top (1) button then cali.failed displays.

VIEW EXERCISE RECORD DURING SWIMMING

You could start swimming by following the below steps.
NOTE Make sure the watch has enough memory, otherwise no memory displays when you press button after SWIMMING mode.
To view swimming records:
1. In SWIMMING mode, press top (1) button to enter start mode.
2. Toggle middle (2) button to select swim type and pool size (see above sections).
3. The watch starts counting. Only Auto lap is available during swimming, the stroke (stk), time (00'00'00) and calories (Cal) counting data automatically display on the
screen. Lap counting data displays when it reaches the setting.
OR
While viewing the screen and pressing top (1) button to pause the counting,
the SWIMMING mode screen displays. Go directly to above step 1 for counting again.
NOTE If you set the watch to automatically toggle screens, the last three screens automatically toggle to display every 5 seconds. Please see SET USER PROFILE for
turning on the toggle feature.
NOTE If the lap counting reaches the 100th or the total hours of the exercise reaches 80 hours, memory full displays on the screen with a long beep. You need to clear
the memory for further exercise purpose.
stops flashing, then select continue or stop. If you press bottom (3) button to stop counting,
14