Tripp-Lite SmartOnline SUTX20K Manual Del Propietário página 36

6. Communication Interfaces
7 REPO Port
The REPO port is for remote emergency power off. When an emergency event occurs, it will disconnect the UPS power supply rapidly
and shut down the UPS immediately. The configuration is shown as follows.
8 Charger Detection Port
The charger detection port is used to connect with an external charger box. With this port, the UPS can detect the operating status
of the external charger box and control its switch.
As shown in the diagram below, there are two signal sources. One signal source controls the on/off charging mechanism and the
other signal source detects the charging status (fail/no fail).
2K(1206)
2K(1206)
GS
UPS
(Figure 6-8: REPO Port Configuration)
36
2
+12VSF 1