Adjusting Air Flow Direction - Hiyasu ASE 18UIAM Manual De Funcionamiento

06Manual 26Hiyasu ENG 2/1/07
Lever
15:25 Página 47

ADJUSTING AIR FLOW DIRECTION

• Adjust the air flow direction properly otherwise, it might cause discomfort or
cause uneven room temperatures.
• Adjust the horizontal louver using the remote controller.
Adjust the vertical louver manually.
•
Adjusting the Vertical Air Flow Direction (up - down)
The air conditioner automatically adjusts the vertical air flow direction in accordan-
ce with the operating mode.
To set the vertical air flow direction
Perform this function while the unit is in operation.
Keep pressing the AIR DIRECTION button on the remote controller to move the
louver to the desired direction.
• Adjust the vertical air flow direction to the desired direction.
• In subsequent operations, the vertical air flow is automatically set in the direc-
tion to which you adjusted the louver by pressing the AIR DIRECTION button.
To set the horizontal air flow direction (left - right)
Adjust the vertical louver manually using the lever on the left or right side of the ver-
tical louver arm (Depending on model). Take care not to catch fingers on the fan,
horizontal louver or to damage vertical louvers. When the air conditioner is in ope-
ration and the horizontal louver is in a specific position, move the lever at left (or
right, depending on model) end of the air outlet to the desired position.
To automatically swing the air flow direction (up - down)
Perform this function while the air conditioner is in operation.
Press the SWING button on the remote controller.
•
To stop the function, press the SWING button again.
Press AIR DIRECTION button to lock louver in desired position.
•
The AIR DIRECTION and SWING buttons will be disabled when the air con-
•
ditioner is not in operation (including when the TIMER ON is set).
Do not operate the air conditioner for long periods with the air flow direction
•
set downward in cooling or dry mode. Otherwise, condensation may occur
on the surface of the horizontal louver causing moisture to drop on to the floor
or on furnishings.
• Do not move the horizontal louver manually. Always use the AIR DIRECTION
or SWING button. If you move this louver manually, it may malfunction
during operation. If the louver malfunctions, stop the air conditioner once
and restart it.
• When the air conditioner is started immediately after it was stopped, the hori-
zontal louver might not move for approximately 10 seconds.
• Open angle of the horizontal louver should not be set too small, as COOLING
or HEATING performance may be impaired due to too restricted air flow area.
• Do not operate unit with horizontal louver in closed position.
When the air conditioner is connected to power (initial power), the horizontal
•
louver may generate a sound for 10 seconds, this is a normal operation.
CAUTION
47