Checks Before Operation - Hiyasu ASE 18UIAM Manual De Funcionamiento

06Manual 26Hiyasu ENG 2/1/07
50
15:25 Página 50
MAINTENANCE
4-
Remove the Electrostatic Filter from its support frame as shown in the Figure on
the left.(Not applicable to the unit without)
Do not touch this Electrostatic Filter within 10 minutes
after opening the inlet grille, it may cause an electric
shock.
Electrostatic
Filter
• Clean the Electrostatic Filter with mild detergent or water and dry in the sunlight
for two hours.
• Before re-install the Electrostatic Filter, check whether the corona line or sup-
port frame is damaged or not.
5-
Install the air freshening filter back into position.
6-
Insert the upper portion of air filter back into the unit taking care that the left and
right edges line up correctly and place filter into position.
Maintenance
If you plan to idle the unit for a long time, perform the following:
(1) Operate the fan for about half a day to dry the inside of the unit.
(2) Stop the air conditioner and disconnect power.
Remove the batteries from the remote controller.
(3) The outdoor unit requires periodic maintenance and cleaning. Do not
attempt to do this yourself.
Contact your dealer or servicer.

Checks before operation

• Check that the wiring is not broken off or disconnected.
• Check that the air filter is installed.
Check if the air outlet or inlet is blocked after the air conditioner has not been
•
used for a long time.
• Do not touch the metal parts of the unit when removing the filter. Injuries can
occur when handling sharp metal edges.
• Do not use water to clean inside the air conditioner.
Exposure to water can destroy the insulation, leading to possible electric
shock.
When cleaning the unit, first make sure that the power and circuit breaker are
•
turned off.
CAUTIONS