Connecting The Ac/Dc Adapter; Switching On The Printer; Inserting The Print Head - Olivetti JP 90 Manual Del Usuario

All manuals and user guides at all-guides.com

Connecting the AC/DC Adapter

The AC/DC adapter (item B on page III) serves as the power
supply for your printer when you are working in an office
environment.
As the AC/DC adapter is powered as soon as it is con-
nected to the electrical power supply, make sure that it is
NOT plugged into the power supply socket when
connecting its jack to the printer.
Make sure that the voltage indicated on the electrical data
plate on the base of the AC/DC adapter corresponds to that of
your electrical power supply.
If the voltage indicated is not that supplied, call your local
retailer immediately. DO NOT, UNDER ANY CIRCUMSTANCES,
CONNECT THE AC/DC ADAPTER.
Make sure that the plug on the power cable of the AC/DC
adapter is of the type accepted by the power socket you intend
to use; if it is not, call your local retailer. Do NOT attempt to
change the plug yourself.
The manufacturer declines all responsibility for accidents to
pe r s o n s o r d a m a g e t o t h e p r i n t er a rising from the
non-observance of this warning.
•
Place the printer and the AC/DC adapter on a flat surface.
•
Plug the AC/DC connector jack into the socket marked
DC-IN on the rear of the printer (see figure on page V).
•
Insert the plug of the AC/DC adapter in the power socket
Instead of the AC/DC adapter, your can use 10 market
standard LR6/AA type batteries (see figure on page V), or
2
either of the optional battery packs (item 1 on page IV)
available ( see "Using Batteries" in the User Guide ).

Switching on the Printer

•
Press the POWER key on the operator panel to switch on
the printer.
The light indicators on the operator panel flash once in
sequence, and the POWER light indicator remains lit.
Whenever you switch on the printer, it undergoes a series of
internal checks and a mechanical reset is executed (a slight
noise is audible).

Inserting the Print Head

See the sequence of figures on page VI and the
instruction template on the inside of the front cover.
•
Open the sealed print head container (item C on page III)
and remove the print head, holding it by the casing (the
end opposite the protective film).
•
Still holding the print head casing, remove the protective
film.
Do not touch the electrical contacts or the printing
nozzles nor sit the print head on either of them.
•
With the printer already powered, press the CARTRIDGE
key on the operator panel to move the print head carriage
to the head loading position.
Quick Start