Stryker Isolibrium 297300000000 Manual Del Usuario página 26

C C l l e e a a n n i i n n g g
C C A A U U T T I I O O N N
• Always unplug the support surface power/data cable before you clean or disinfect.
• Do not immerse the support surface or foot box in cleaning or disinfectant solutions.
• Do not allow fluid to pool on the support surface. Fluids may cause degradation of components and may cause
unpredictable safety and performance of this product.
• Always inspect the support surface covers (top and bottom) for tears, punctures, excessive wear, and misaligned
zippers as you clean the covers. If the cover is compromised, remove the support surface from service immediately and
replace the cover to prevent cross-contamination.
• Always perform preventive maintenance based on the use of the product. An increase in the use of the product may
include more frequent cleaning and disinfection and may adversely affect the life of the support surface.
• Always wipe each product with clean water and dry after you clean or disinfect. Some cleaning and disinfecting agents
are corrosive in nature and may cause damage to the product. Failure to properly rinse and dry the product leaves a
corrosive residue on the surface of the product and may cause premature degradation of critical components. Failure to
follow these cleaning or disinfecting instructions may void your warranty.
• Do not iron, dry-clean, tumble dry, or power wash the support surface or support surface covers.
P P r r e e r r e e q q u u i i s s i i t t e e : : A minimum of two operators are required to clean the bottom support surface cover.
Always follow hospital protocol for cleaning and disinfecting.
To clean the support surface covers between patient use, follow these steps in order:
1. If powered, unplug the bed from the wall outlet. Turn the battery switch to off.
2. Unplug the support surface power/data cable from the bed.
3. Remove the power/data cable from the strain relief bracket.
4. Using a clean, soft, damp cloth, wipe the support surface covers with a mild soap and water solution to remove foreign
material.
5. Wipe the support surface covers with a clean, dry cloth to remove any excess liquid or cleaning agent.
6. Rinse and dry the support surface covers.
7. Turn the bed battery switch to on.
8. Plug the bed power cord into a hospital grade protective earthed outlet.
9. Plug the support surface power/data cable in through the strain relief.
N N o o t t e e - - Dry the support surface covers before you store, add linens, or place a patient on the surface.
EN 22 2973-009-005 Rev AD.0