4 - Characteristics of the machine
The machines of the BARISTA T series have been designed to prepare espresso and
hot drinks.
The operating principle consists of a volumetric pump inside the machine that feeds
the hot water and steam boiler, in addition to the independent coffee groups. By
activating the controls, the water is sent to the external brewing units in the form of hot
water or steam according to the needs.
The water to be used to prepare the drinks is taken at the moment of the water network,
pressurized by the pump, passing through a pre-heating circuit through the hot water /
steam boiler, and its temperature is finally raised from the temperature from pre-heating
to working by a heat exchanger.
Each one of the spreader groups, as well as the hot water / steam boiler, can present
a different working temperature, as well as different independent configuration
parameters to optimize the machine's performance before the needs of the user.
The machine is formed by a supporting structure in steel to which the mechanical and
electrical components are fixed. The productive operations are carried out on the front
of the machine and the controls, the control devices and the coffee brewing groups are
located. In the upper part of the machine there is a surface destined to heat the cups.
BARISTA T PLUS/ONE
Voltage
Power (w)
Steam boiler (w)
Coffee group (w)
Steam boiler
Max. Pressure (mpa)
Working pressure (mpa)
Volume (l)
Size (mm)
Weight (kg)
Water inlet
Min/max pressure (mpa)
Drain pipe diameter (mm)
1 Coffee filter holder
2 Coffee filter holder
Blind filter
Tamper
Drain pipe
Incoming water pipe
BARISTA T 1GR
BARISTA T 2GR
380V 3F
3500
2000
1x1000
0,27
0,18
4,5
440x550x465
700x550x465
52
3/8"
0,1 / 0,6
0,1 / 0,6
1
BARISTA T 3GR
5500
6500
3500
3500
2x1000
3x1000
0,27
0,27
0,18
0,18
8,5
8,5
920x550x465
65
85
3/8"
3/8"
0,1 / 0,6
16
1
2
3
1
1
1
1
9