Moving The Machine; Storing - Nussbaum TC 210 Manual De Instrucciones

ENGLISH • Instructions manual

13. MOVING THE MACHINE

Follow the procedures outlined below when moving the machine:
1) Close the turntable grippers all the way towards the centre.
2) Turn the table so that the its straight sides are lined up the projected line
of the side panels (See Fig. O/1).
3) Disconnect all power sources.
4) Clamp the pedal (7, Fig. G) with a wedge underneath it.
5) Remove the horizontal arm casing by unscrewing the fixing nuts (1, Fig.
O/1
O/2).
6) Move the horizontal arm (11, Fig. G) all the way back.
7) Sling the machine with lifting straps at least 60 mm wide.
8) Pass the first strap behind the horizontal arm as shown in Fig. O/3.
9) Pass the second strap between the two front slots on the turntable plate as
shown in Fig. O/1.
1
10) Gather the ends of the slings in a suitable ring above the machine (see
Fig. O/4).
O/2
11) Hoist and move the machine with a sufficiently strong lift truck.
O/4
O/3

14. STORING

If the machine has to be stored for a long time, disconnect it from all power sources.
Grease all the parts that could be damaged if they dry out:
- slides
- their slots on the turntable
Empty any oil/hydraulic fluid reservoirs. Wrap the machine in a sheet of protective plastic to prevent dust from reaching the internal working
parts.
TC 210 - Liga C 230
39