Benelli 302R Manual Del Propietário página 112

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

Total/partial kilometre counter
The total kilometre counter shows the to-
tal distance covered in kilometres.
Set in the mode instrumentation "TRIP A /
TRIP B" with the "SELECT" button.
The partial kilometre counter (TRIP A/TRIP
B) shows the distance covered since the
last reset in kilometres.
The partial kilometre counter can be used
to estimate the possible distance to cover
with a full tank of fuel. This information
may make it possible to schedule future
fuelling stops.
RESET/SELECT buttons
Buttons to set vehicle data.
Press the "SELECT" button to see the par-
tial or total kilometres.
When viewing partial kilometres (TRIP
A/ TRIP B), it is possible to reset them by
holding down the "RESET" button for 3
seconds.
Transmission gear display
The transmission gear display shows the
selected gear.
This model is equipped with 6 gears.
Anti-lock Brake System (ABS) warning
light
1. ABS error: whenever any fault is de-
tected and saved, the ABS diagnostic light
is on.
The ABS diagnostic light will turn off with
the next SHUTDOWN/ IGNITION of the in-
strument panel or when the vehicle exce-
eds the speed of about 5 km/h.
2. Disabled ABS mode: the ABS diagno-
stic light will flash once for about 1.30 se-
conds (short flashing).
3. By keeping the ABS button pressed for a
time of 3/30 seconds, the ABS diagnostic
light will flash once for about 0.30 se-
conds (short flashing).
4. ABS activated: When the instrument
panel is on, the ABS diagnostic light will
be on until the vehicle reaches the speed
of about 5 km/h. Once having exceeded
this speed, the diagnostic light will turn
off.
WARNING
Usually the ABS diagnostic light stays
on when the instrument panel is swi-
tched on and turns off when the vehi-
cle speed is above 5 km/h. Is the ABS
diagnostic light shows one of the fol-
lowing symptoms, one or more faults
may have been occurred on the ABS
system. In which event, take the motor-
cycle to an authorized Benelli service
centre.
• The ABS diagnostic light does not
go on when the instrument panel is
3 - 5
Instrument and control functions
switched on.
• The ABS diagnostic light will stay on
even when the vehicle exceeds the
speed of about 5 km/h.
It is important to point out the fact that
the ABS is not active when the light is
on, but the braking system will continue
working as a normal system not equipped
with ABS.
In this situation, a hard braking may lock
the wheels, causing slip and loss of stabili-
ty of the motorcycle.
EN
3

Hide quick links:

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido