Sidestand - Benelli 302R Manual Del Propietário

NOTICE
Remove the rear mudguard before to
perform spring preload adjustment.
WARNING
Read and understand the following in-
formation before handling the shock
absorber assembly.
• Do not tamper with or attempt to
open the cylinder assembly.
• Do not subject the shock absor-
ber assembly to an open flame or
other high heat source. This may
cause the unit to explode due to
excessive gas pressure.
• Do not deform or damage the
cylinder in any way. Cylinder da-
mage will result in poor damping
performance.
• Do not dispose of a damaged or
worn-out shock absorber assem-
bly yourself. Take the shock absor-
ber assembly to a Benelli dealer
for any service.

Sidestand

The sidestand is located on the left side of
the frame. Raise the sidestand or lower it
with your foot while holding the vehicle
upright.
TIP
The built-in sidestand switch is part of the
ignition circuit cut-off system, which cuts
the ignition in certain situations.
(See the following section for an explana-
tion of the ignition circuit cut-off system.)
3 - 15
Instrument and control functions
WARNING
The vehicle must not be ridden with
the sidestand down, or if the sidestand
cannot be properly moved up (or does
not stay up), otherwise the sidestand
could contact the ground and distract
the operator, resulting in a possible
loss of control.
Benelli's ignition circuit cut-off system
has been designed to assist the opera-
tor in fulfilling the responsibilityof rai-
sing the sidestand before starting off.
Therefore, check this system regularly
and have a Benelli dealer repair it if it
does not function properly.
EN
3