Metra 99-5838CH Instrucciones De Instalación página 4

7. Unclip the shifter trim bezel and slightly
pull it up to clear the center console
removal.
8. Open the center console storage
compartment, unclip the top of the
console, and then slide it toward the
rear of the vehicle to remove it.
(Figure G)
9. Remove the plastic tray in front
of the shifter.
10. Remove the center plastic trim
(knockout) between the power outlet
and USB jack. (Figure H)
4
DASH DISASSEMBLY
(Figure G)
(Figure H)
(CONT.)
Ensure that the vehicle is completely
off before proceeding onto the
following (4) steps:
11. Remove the (4) 9/32" screws securing
the radio/climate control panel, and then
unclip, unplug, and remove. (Figure I)
12. Remove the (4) 9/32" screws securing the
display screen, then unplug and remove.
(Figure J)
13. Remove the (4) 9/32" screws securing the
radio chassis, then unplug and remove.
(Figure J)
14. If the vehicle is equipped with SYNC,
remove the (3) 9/32" screws securing the
SYNC® module, then unplug and remove.
Continue to Kit Preparation
(Figure I)
(Figure J)
|
1.800.221.0932 MetraOnline.com