Accessories; Troubleshooting - Luminance Brands Kathy Ireland Home EUCLID CF500AP00 El Manual Del Propietario

S e e y o u r l o c a l L u m i n a n c e B r a n d s d e a l e r ,
www .luminancebrands .com or our catalog for these

accessories:

• Ceiling Fan Receiver / Remote Controls
• Downrod Extension Kits
• Slope Ceiling Kit
• Ceiling Fan Light Kit
WARNING
!
The use of any other control not specifically approved
for this fan could result in fire, shock and personal
injury.
FOR YOUR OWN SAFETY TURN OFF POWER AT MAIN FUSE BOX OR CIRCUIT BREAKER PANEL BEFORE
TROUBLESHOOTING YOUR FAN.
TROUBLE
1. Fan will not start. 1 . Fuse or circuit breaker blown .
2 . Reversing switch in neutral position .
2. Fan sounds
1 . Blades not attached to fan .
noisy.
2 . Loose screws in motor housing .
3 . Screws securing fan blade flanges to
motor hub are loose .
4 . Screws holding blades to flanges
are loose .
3. Fan wobbles
1 . Setscrews in motor coupler are loose .
excessively.
2 . Setscrew in hanger ball/downrod
assembly is loose .
3 . Screws securing fan blade flanges to
motor are loose .
4 . Fan blade flanges not seated properly .
5 . Hanger bracket and/or ceiling outlet
box is not securely fastened .
6 . Fan blades out of balance .
11. Accessories

12. Troubleshooting

WARNING
!
PROBABLE CAUSE
20
WARNING
!
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product
by Luminance Brands. Substitution of parts or
accessories not designated for use with this product
by Luminance Brands could result in personal injury
or property damage.
SUGGESTED REMEDY
1 . Check main and branch circuit fuses or circuit breakers .
!
Make sure main power is turned OFF.
2 . Make sure reversing switch position is all the way to
one side .
1 . Attach blades to fan before operating .
2 . Check to make sure all screws in motor housing
are snug (not over-tight) .
3 . Check to make sure the screws which attach
the fan flanges to the motor hub are tight .
4 . Tighten screws securely .
1 . Tighten both setscrews securely in the motor coupler .
2 . Tighten the setscrew in the hanger ball/downrod
assembly .
3 . Check to be sure screws which attach the fan
blade flanges to the motor are tight .
4 . Check to be sure the fan blade flanges seat
firmly and uniformly to the surface of the motor .
If flanges are seated incorrectly, loosen the
flange screws and retighten according to the
procedure in the section on "Ceiling Fan Assembly" .
5 . Tighten the hanger bracket screws to the outlet
box, and/or secure outlet box .
6 . Interchanging an adjacent (side-by-side) blade pair can
redistribute the weight and result in smoother operation .
WARNING
U.L. Model No.: CF500