Luminance Brands Kathy Ireland Home EUCLID CF500AP00 El Manual Del Propietario página 9

3. Ceiling Fan Assembly
3.11
Route the Three Motor Wires through the Hanger Ball
(Figure 11) .
Reinstall the Hanger Ball on the Downrod as follows:
Position the Pin through the Two Holes in the Downrod
and align the Hanger Ball so the Pin is captured in the
Groove in the top of the Hanger Ball (Figure 11) .
Pull the Hanger Ball up tight against the Pin and
securely retighten the Phillips Head Set Screw in the
Hanger Ball (Figure 11) .
NOTE: A loose Phillips head set screw could create
fan wobble.
3.12
The Fan comes with Black, Blue and White Wires that
are 80" long .
Measure up approximately 6 to 9-inches above top of
Hanger Ball / 4 .5" Downrod Assembly (Figure 12) .
Cut off excess Wires and strip back insulation 1/2-inch
from end of Wires .
(Continued)
4.5" DOWNROD
PHILLIPS HEAD
SET SCREW
Figure 11
1/2-INCH
6 TO 9
INCHES
Figure 12
9
PIN
BLUE WIRE
BLACK WIRE
WHITE WIRE
HANGER BALL
luminancebrands.com
Please contact 1-800-777-4440 for further assistance
U.L. Model No.: CF500
HANGER
BALL