Ikegami ISD-A30 Manual De Instrucciones página 20

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

* Note: In the S/N, STD or MOVE mode, the gain control levels LOW, MID and
HIGH cannot be selected.
(4) SLOW SHUTTER
The electronic sensitivity multiplying factor can be adjusted with the L and
R buttons. x2, x4, x8, x16, x32
The higher the factor, the higher the sensitivity, but motions at maximum
factor look unnatural.
8-4-4. WHITE BALANCE
(1) The white balance modes can be selected with L and R buttons.
① ATW (Initial setting)
White balance is automatically changed to full time auto-tracking.
② ATW ex
White balance is automatically changed to full time auto-tracking, but
the covering area of color temperature range gets higher than the ATW
mode.
Compared with the ATW mode, an accuracy of white tracking is not
very good in this mode, but in certain conditions this may powerful to
compensate color differences.
* It is recommended to use ATW in in-doors, while ATW ex is for out door
use.
③ AWC
This is the so-called one-push automatic white balance control. Shoot
a target white subject and press the E button, and the white balance
will be adjusted.
④ MANUAL
Select MANUAL, press the E
button and the screen at left
appears onscreen.
R GAIN is used to adjust the
reddish color. B GAIN is used
to adjust the bluish color.
      WHITE BALANCE
→R GAIN     
 B GAIN     
 RET
E-17

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido