Pre-Work Before Installation; Camera Installation (Ceiling) - Ikegami ISD-A30 Manual De Instrucciones

4. Camera Installation

4-1. Pre-work before installation

Make holes for cable wiring and to fix a camera.
For camera fixing, two holes are needed. About 4mm diameter holes are
recommended.
For the hole for cable, a diameter of the opening should be at least 50mm to
60mm. Please make it with utmost care not to give damage to wires.
Holes for camera fixing
4-2. Mounting the camera (Ceiling)
Please prepare suitable screws to fix the camera depending upon a materials
and hardness of ceiling. Screws for fixing the dome camera are not supplied.
Put two fixing screws leaving about 5mm clearance. Those two screws will be
tightened later to secure the dome camera. Put the cable wiring through the
center hole of the camera base ①, and align two key hole slot to the screws.
And turn the unit clockwise until it stops and tighten two fixing screws. Put
back the dome cover with an ornamental ring.
②
①
③
E-4
Size of hole for cables
on the ceiling.
φ 50 〜φ 60
Screws
Camera
Dome cover
Ornamental ring