STOK Island SGP2220SB Manual Del Operador página 10

STEP 2: ASSEMBLING STORAGE SHELF TO
RIGHT SIDE LEGS
See Figure 6.
Remove the following hardware from the blister pack:
AA - 4 Screws (M5 x 12 mm)
BB - 4 Flat washers (M5)
CC - 4 Lock washers (M5)
 Turn the storage shelf upside down and slide over the right
side legs. Legs go through the corner brackets located
on underside of shelf.
 Line up holes in leg with holes in corner bracket.
 Slide a screw (AA), lock washer (CC), and flat washer (BB)
through corner bracket and into leg. Tighten securely.
 Repeat steps for other screw and leg.
SECONDARY TABLE
(SHOWN BOTTOM
WASHER
SIDE UP)
HOLES
Fig. 6
FLAT
(BB)
CORNER
BRACKET
SCREW
(AA)
LOCK
WASHER
(CC)
ASSEMBLY
STEP 3: ASSEMBLING LEFT LEG SECTIONS
TO STORAGE SHELF
See Figure 7.
Remove the following hardware from the blister pack:
AA - 4 Screws (M5 x 12 mm)
BB - 4 Flat washers (M5)
CC - 4 Lock washers (M5)
 Insert each left leg section through the slots on the un-
derside of the storage shelf.
 Align the holes in the left leg sections with the holes in
the leg brackets.
 Slide a lock washer (CC) and flat washer (BB) onto each
screw (AA) and insert the screw through the holes in the
bracket and leg. Tighten securely.
 Repeat steps for other screw and leg.
LEG
LEFT SIDE LEG
SECTIONS
Fig. 7
10
LOCK
WASHER
(CC)
SCREW
(AA)
FLAT
WASHER
(BB)
LEG
BRACKET