STOK Island SGP2220SB Manual Del Operador página 23

 Once burner tubes are clear of debris, use a wire brush to
remove food and dirt from the outer surface of the tubes.
 Check burner for damage. Normal wear and corrosion
may cause some holes to enlarge. Replace burners if this
happens.
NOTE: Burner tubes must reengage valve openings.
 Verify that the gas valve orifice is correctly positioned
inside burner inlet.
 Attach the electrode to the burner and carefully replace
the burners.
 Slide burners into brackets inside the grill and secure
burners using hitch pins.
 Reattach electrode wires to the electronic ignitor.
BURNER FLAME CHECK
See Figure 33.
 Close cylinder valve completely.
 Remove heat grates.
 Turn on cylinder valve completely.
 Light burners and turn the control knobs from high to low.
A smaller flame should been seen on low while the high
positions flame should be approximately 1 in. in height.
 If only a low flame is seen, you may need to reset
the gas regulator safety device as described in the Op-
eration section.
Fig. 33
HOSE CHECK
Close cylinder valve completely. Inspect all hoses before
each use. If hoses need replaced please call
or visit us online at www.
IGNITOR CHECK
Close cylinder valve completely. Press and hold the
ignitor. "Click" should be heard and a spark seen
between the burner and electrode. If no spark, see the
Troubleshooting section later in this manual.
MAINTENANCE
1-800-847-5993
.com.
stokgrills
VALVE CHECK
Close cylinder valve completely. Control knobs lock
in place when turned off. To check valves: push in
knobs and release. If knobs don't spring back please call
1-800-847-5993
replace the valve assembly.
STORING THE GRILL
See Figure 34.
 Turn all control knobs on the control panel off.
 Close cylinder valve completely.
 Hold regulator firmly and turn coupling nut counterclock-
wise to disconnect the regulator from the LP gas cylinder.
 Place dust cap on cylinder valve outlet whenever the
cylinder is not in use. Only install the type of dust cap on
the cylinder valve outlet that is provided with the cylinder
valve. Other types of caps or plugs may result in leakage
of propane.
 Once cooled, clean grill thoroughly.
 Store in dry location. If storing outside, place hood over
grate and cover grill with one of the variety of grill covers
offered by manufacturers to protect from rain.
HIGH
LOW
Fig. 34
23
or visit us online at www. .com. to,
stokgrills