Publicidad
Idiomas disponibles
Idiomas disponibles
9 Both red CLICKTIGHT release buttons are visible after installation.
9 All connections are secure and vehicle belt is not twisted.
9 Car seat base MUST be flat on vehicle seat and MUST be parallel to
vehicle seat.
9 Recline indicator is still within the correct section for REAR-facing, after
child is secured.
9 Child restraint cannot be moved front to back or side to side more than
1 in. (2.5 cm) at the belt path.
9 Excess top tether webbing is contained within your vehicle and secured.
NOTE: If the child restraint does not meet the above
criteria, repeat the installation steps or use a different
seating location in your vehicle.
Installation with Vehicle Lap Belt Only
1� Place child restraint REAR-
facing on the vehicle seat
so that the car seat base is
flat on the vehicle seat and
is parallel to vehicle seat.
2� Recline child restraint to the
appropriate position. Refer
to page 15 to determine
appropriate recline position.
3� Ensure that no more than
3 in (7.5 cm) of the base
hangs over front edge of
the vehicle seat.
4� Open the CLICKTIGHT.
Squeeze the CLICKTIGHT
release buttons underneath
the front cover flap and lift
to open.
22
Table of Contents
5� Route the lap vehicle
seat belt through the
REAR-facing belt path
marked by blue labels.
6� Ensure the belt is not twisted
then buckle the vehicle seat
belt.
7� Lock and remove slack from
vehicle seat belt.
NOTE: Make sure that the
vehicle seat belt is locked
as directed by your vehicle
owner's manual.
8� Close the CLICKTIGHT
over the vehicle seat
belt.
9� Ensure both red
CLICKTIGHT release
buttons are visible.
NOTE: If it is difficult to close,
you may have removed too
much slack.
3 in
3 in
Table of Contents
CLICK
23
Publicidad
