IRUDEK CTA14 Manual De Instrucciones página 17

LIFETIME
-The estimated product lifetime is 11 years from the date of manufacture (1 year storage + 10 years
for use). The following factors can reduce the lifetime of the product : intense use, contact with
chemical substances, specially agressive environment, extreme temperature exposure, UV exposure,
abrasion, cuts, violent impacts, bad use or maintenance. The required annual examinations will
validate the correct functioning of the equipment. It is compulsory that the equipment is examined
by the manufacturer or his authorized representative at least once a year.
In case that it have been used to arrest a fall, the equipment must be withdrawn from use.
TRANSPORT
The Personal Protective Equipment must be transported in a package that protects it against
moisture or mechanical, chemical and thermal attacks.
INSTRUCTIONS FOR MAINTENANCE
- CLEANING: The personal protective equipment must be cleaned without causing adverse
effect on the materials used in the manufacture of the equipment. For textile ( webbing and ropes )
and plastic parts wipe with cotton cloth or a soft brush. Do not use any abrasive material. For
intensive cleaning wash the harness at a temperature between 30ºC and 60ºC using a neutral
detergent. For metallic parts wipe with a wet cloth. When the equipment becomes wet, either from
being in use or when due to cleaning, it shall be allowed to dry naturally, and shall be kept away
from direct heat.
- STORAGE: Personal protective equipment should be stored loosely packed, in a dry and
well - ventilated place, protected from direct light, UV degradation, dust, sharp edges, extreme
temperature and aggressive substances.
REPAIR
Any repair shall only be carried out by equipment manufacturer or his authorized representative
following manufacturer's procedures.
MARKING The equipment is marked with the next information:
i) CE marking, Conformity to European Legislation
ii) Identification of the manufacturer
iii) Reference of the equipment
iv) Lot number or serial number
v) Year of manufacture
vi) Material
vii) European Norm
viii) Notified body number
ix) Pictogram to indicate the necessity for user to read the instruction for use
INSTRUCTIONS FOR PERIODIC EXAMINATIONS
It is necessary to carry out regular periodic examinations. The safety of the users depend upon the
continued efficiency and durability of the equipment.
The personal protective equipment shall be examined at least every 12 months. The periodic
examination can only be carried out by the manufacturer or his authorized representative.
The comments should be included in the check card of the equipment. After the periodic
examination, the next due date for periodic examination will be determined.
During periodic inspection it is necessary to check the legibility of the equipment marking
The check card should be filled in before the first use.
CHECK CARD