Transmission Definition - Pratissoli KF Serie Manual De Uso

The radial load on the shaft must not exceed 7500 N
(value necessary for Layout definition). The transmission is
considered adequate if the load is applied at a maximum
distance a=40 mm from the shaft shoulder (P.T.O) as shown in
Fig. 10.
9.11

Transmission definition

To prevent irregular radial loads on the shaft and the relative
bearing, follow these directions:
a) Use pulleys with V-belts with the size of the groove
required/recommended by the manufacturer of belt used.
In the absence of directions, follow Fig. 8 and the table in
Fig. 9.
Break
corners
Single groove Multiple groove
Fig. 8
30
For dimensions differing from those specified
above, contact our Technical or Customer Service
Departments.
Fig. 7