ims PRO MIG CARPRO 1 Manual Del Usuario página 23

Translation of the original instructions
Reel :
- Open the hood (1)
- Remove the reel holding nut (2) (NB. : no reversed screw)
- Tighten the locknut (3) to bulge the reel axis (do not tighten too much)
- Insert the reel-To insert the wire in the rollers, apply pressure on the «roller tension setting screw »
Torch:
- Pull out the wire of the torch 1 in winding up the reel.
- Pull out the torch 1.
- Plug the power connector of the spool on gun on the connector.
- Plug the control connector of the spool gun-Place the switch on position 1.
ADVICE AND THERMAL PROTECTION
- Respect the basic rules of welding.
- Leave the air holes of the device open to allow air circulation.
- Leave the device plugged after welding to allow its cooling.
- Thermal protection: The light (fig V-6) turns on and the cooling duration is a couple of minute according to the area
temperature.
SYMPTOMS
The welding wire speed is not constant.
The unwinding motor doesn't operate.
Bad wire unwinding.
No welding current
The WIRE rubs down after the rollers.
MIG CARPRO 1 / 3 / 3 DV
POSSIBLE REASONS
Cracklings blocking up the opening.
The wire skids in the rollers.
Reel or roller brake too tight.
Electrical supply problem.
Covering wire guide dirty or damaged.
Reel brake too tight
Bad connection to the mains supply.
Bad earth connection.
Power contactor inoperative.
Covering WIRE guide crushed.
Locking of the wire in the torch
No capillary tube.
Wire speed too fast
SOLUTIONS
Clean out the contact batch or change it
and replace the anti-adherence product.
Control the roller pressure or replace it.
Wire diameter non-consistent with roller
Covering wire guide in the torch not
consistent with wire.
Release the brake and rollers.
Check that the running button is on the
position on.
Clean or replace
Release the brake
Check the branch connection and ensure
it is fed by 3 phases.
Control the earth cable (connection and
clamp condition).
Control the torch trigger.
Check the covering and torch body.
Clean or replace.
Check the presence of capillary tube.
Reduce the wire speed
EN
23