ims PRO MIG CARPRO 1 Manual Del Usuario página 24

Translation of the original instructions
The weld bead is porous.
Very significant flashing particules.
No gas at the torch output.
The Spool on Gun does not work.
In Spool on Gun mode, the speed adjus-
tement knob on the machine does not
work.
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
24
MIG CARPRO 1 / 3 / 3 DV
The gas flow is not sufficient.
Gas bottle empty.
Gas quality non-satisfying.
Air flow or wind influence.
Gas nozzle too full.
Bad wire quality.
Surface to weld in bad condition. (rust,
etc...)
Arc voltage too low or too high.
Bad earth connection.
Protecting gas insufficient.
Bad gas connection.
Connection problem
Normal condition of the machine.
Adjusting range 15 to 20 L / min. Clean
the working metal.
Replace it.
Replace it.
Avert air blast, protect welding area.
Clean or replace the gas nozzle.
Use adapted WIRE for MIG-MAG welding.
Clean the working parts before welding.
See welding settings.
Check and place the earth cable to have a
better connection.
Adjust the gas flow.
See if the gas coupling beside the engine
is well connected.
Check the torch connections (power and
control connectors).
When Spool on Gun is used, only the wire
speed knob on the torch is working.
EN