Installing The Edge Guard; Product Overview - Toro PowerPlex 51481 Manual Del Operador

5

Installing the Edge Guard

Parts needed for this procedure:
1 Wire edge guard
Procedure
Slightly spread the ends of the wire edge guard apart
and insert the ends into the holes in the trimmer
housing as shown in Figure 6.
Figure 6

Product Overview

Specifications
Appropriate Temperature Ranges
Charge the battery at
Use products at
Store products at
Unplug the charger if
*Charging time will increase if you do not charge the
battery within this range.
Store the tool, battery pack, and battery charger in an
enclosed clean, dry area.
g203740
10
0°C (32°F) to 40°C (104°F)*
-15°C (5°F) to 60°C (140°F)
-15°C (5°F) to 60°C (140°F)
Below 0°C (32°F) or above
40°C (104°F)