EMAK Oleo-Mac CHEYENNE 92 Manual De Uso página 102

(continued)
Malfunction, defect
The machine
loses power when
travelling up a hill
Extreme vibrations
occur when
travelling
The steering is
slipping through or
loose
The engine does not
run
The engine is
rotating but will not
start up
7.1 Ordering spare parts
We recommend that you use exclusively original spare parts, which ensure safety and compatibility.
Always order spare parts from an authorised distributor or service organisation, which is informed
about the current technical changes performed on the products during manufacture.
For easy, fast and exact identification of the necessary spare part always provide in your order the serial
number found on the second side of the cover of this publication. Also provide the year of manufacture
as shown on the product identification label under the seat.
} When the machine is under a high load and the ambient temperature is
high, then the maximum working temperature of the oil may be exceeded.
Lower the work demands on the machine.
} Check whether any pulleys are damage or deformed. Replace them if
necessary.
} Check whether the belt has any burned spaces or other irregularities.
Replace it if necessary.
} Check the tension of the travel drive belt
its tension.
} Check that the mowing blades are balanced. Balance or replace them if
necessary.
} Check that the space between the pinion and the segment is not too large.
If yes, adjust the cogged segment. Check for wear on the ball and socket
joints. Replace the joints if necessary.
} Check that there is petrol in the petrol tank.
} Check that the prescribed procedure for starting the engine was followed
( 5.2)
} Check the fuse. Replace if necessary.
} Check whether the voltage on the battery terminals is 12 V. On a new
machine check whether the battery was activated and charged. On
new machines replace the spark plug and check that there is not oil
accumulated on the cylinder due to incorrect handling.
} Check that all wire connections are in order and that the electrical system
switches work.
} Check the engine again exactly according to the instructions in the
User's manual of the engine manufacturer. Have the electrical system
checked at a specialised workshop.
} Check that the prescribed procedure for starting the engine was followed
( 5.2) Check that the petrol in the petrol tank is clean.
} Check that the fuel filter is not clogged.
} Make sure that the throttle lever is in the position "CHOKE".
} Check the engine again exactly according to the instructions in the
User's manual of the engine manufacturer. Have the cabling and switches
checked at a specialised workshop.
Remedy
(
102
6.3.10). If necessary adjust