Makita DTDA040 Manual De Instrucciones página 11

Measuring example:
If you configure the following setting, you can read the tool status.
Case 1
Setting item
Torque level
Workable time range
Case 2
Setting item
Torque level
Workable time range
LED indicator / beeper
► Fig.12: 1. LED indicator
LED indicator / beeper on the tool shows the following functions.
Alarm No.
E0 Battery installation
error
E1 Auto-stop
E2 Anti-reset of
controller
E3 Auto-stop with low
remaining battery
capacity
E4 Overload protection
E5 Overheat protection
E6 Motor lock
E7 Motor failure
E8 Switch failure
E9 Alarm for a long
period of use
Tool setting
23
shortest: 2.5 sec.
longest: 3.5 sec.
Tool setting
23
shortest: 2.5 sec.
longest: 3.5 sec.
Function Status of the tool
If the battery car-
tridge is installed
with the switch
trigger pulled, the
tool stops to avoid
unintentional start.
The battery power
became low and it is
time to replace the
battery cartridge.
The battery voltage
dropped abnormally
for some reason, and
the tool stopped.
The battery power is
almost used up and
the tool stopped.
The tool was over-
loaded and stopped.
Tool's controller
heated up abnor-
mally and the tool
stopped.
The motor has been
locked. At this time,
the tool does not
work.
The tool detected a
motor failure. At this
time, tool does not
work.
The tool detected a
switch failure.
The tool has been
turned on for a long
time (Approx. 3
minutes).
Measured result
20
3.5
Measured result
23
3
Status of the LED indicator/beeper
LED indicator
Blinks in red and
green alternatively.
Blinks in red and
green alternatively.
Blinks in red and
green alternatively.
Lights up in red.
Blinks in red and
green alternatively.
Blinks in red quickly.
Blinks in red and
green alternatively.
Blinks in red and
green alternatively.
Blinks in red and
green alternatively.
Blinks in red and
green alternatively.
11 ENGLISH
Diagnosis
The tool has stopped by the set-
ting of the longest workable time
range (3.5 sec.) before it reaches
the setting of the Tightening Auto
Stop mode (torque level 23).
Diagnosis
The tool has stopped by the
Tightening Auto Stop mode
(torque level 23) before it
reaches the setting of longest
workable time range (3.5 sec.).
Action to be taken
Beeper
A series of long Install the battery
beeps cartridge with
the switch trigger
released.
A series of long Replace the battery
beeps with fully charged
one.
A series of long Replace the battery
beeps with fully charged
one.
A long beep Replace the battery
with fully charged
one.
A series of long Remove the cause
beeps of overload, and
then restart the tool.
Ask your local
Makita Service
Center for repair.
A series of long Remove the battery
beeps cartridge immedi-
ately and cool the
tool down.
A series of long Release the switch
beeps trigger and pull it
again.
A series of long Ask your local
beeps Makita Service
Center for repair.
A series of long Ask your local
beeps Makita Service
Center for repair.
A long beep Release the switch
trigger and pull it
again.