Installing The Fan - BIG ASS FANS Basic 6 Guia De Instalacion

WARNING: Disconnect power to the installation locations before installing the fan and controller!
1. Assemble upper mount
If you are mounting the fan directly to angle irons without the upper mount, extension tube, and lower yoke,
skip to step 7b.
Attach the upper yoke brackets to the pivot bracket with the Standard Mount Hardware. Tighten the bolts to
40 ft·lb (54.2 N·m) using a torque wrench and 3/4" (19 mm) socket.
Loosely attach the mount brackets to the pivot bracket with the remaining Standard Mount Hardware. Install the
center bolts first. Do not fully tighten the hardware. This allows for angle adjustments after the upper mount is
attached to the mounting structure.
Standard Mount Hardware:
a. (10) 1/2-13 x 1-1/2" GR 8 Bolt
b. (20) 1/2" Flat Washer
c. (10) 1/2-13 Nylock Nut
Standard Mount
Hardware Board
Install Upper Yoke Brackets
c
b
Pivot
Bracket
Upper Yoke
Bracket
b
a
10

INSTALLING THE FAN

40 ft·lb (54.2 N·m)
WWW.BIGASSFANS.COM © 2018 DELTA T LLC
Install Mount Brackets
Mount Bracket
b
c
ALL RIGHTS RESERVED.
a
b
DO NOT FULLY
TIGHTEN
Pivot Bracket