Harbor Breeze LP8293LAZ Manual De Usuario página 11

INITIAL ASSEMBLY INSTRUCTIONS
12. Route the wires through the previously removed
hanger ball. Insert the previously removed hanger
ball pin (HH) through the two holes in the downrod
(C) and align the hanger ball so the hanger ball
pin (HH) is captured in the groove in the top of the
downrod (C). Pull the hanger ball up tight against
the hanger ball pin (HH). Securely tighten the
preassembled hanger ball set screw (GG).
CAUTION: A loose set screw could result in a wobbly fan.
Hardware Used
Hanger Ball Set
GG
Screw
Hanger Ball Pin
HH
13. Cut off excess lead wire approximately 6 to 9 in.
above top of the top of the downrod (C). Strip
insulation off 1/2 in. from the end of each lead wire.
12
x 1
x 1
13
11
HH
GG
Lowes.com/harborbreeze
C
C