Aerofeed 5 Wire Feeder - Solter aeroprocess 4110 DV Manual De Instrucciones

AEROFEED 5 WIRE FEEDER

TECHNICAL SPECIFICATIONS
INTERNAL ELEMENTS
The wire feed unit is the device that makes the wire pass through the contact tube of the gun to be melted in the arc.
MIG - MAG machines have a system for varying the wire feed speed and a magnetic valve for the passage of gas.
A motor transmits power to the drive rollers so that they move the wire from the coil to the contact tip of the torch. The
rollers in contact are usually a flat one and a beveled one. The bevel is V-shaped for hard materials such as steel,
U-shaped for soft materials such as aluminum and grooved for tubular steels. It is essential selecting the right roller for
the wire diameter and the kind of material which is going to be used.
EXTERNAL ELEMENTS
Asa de transporte
Siempre que desee manipular la unidad Aerofeed, utilice la asa de transporte. Dicha asa debe utilizarse en caso que
quiera colgar en alto la devanadora. El asa de la unidad debe estar aislada eléctricamente de la estructura metálica
de la cuál será suspendida.
TECHNICAL SPECIFICATIONS
Input voltage (U1)
Maximum output current
Suitable diameter wires
Wire feed maximum speed
Duty Cycle
IP Protection class
Weight
Nº
1 Panel de control
2 Conectores de refrigeración
3 Euroconector
4 Asa de transporte
AEROFEED 5
24V DC
500A DC
De 0,6 a 1,2mm
18m/min
60%
IP23S
15Kg
Nº Description
1 Control panel
2 Roller pressure setting
3 SCART
4 Drive motor
5 Drive rollers
6 Wire guide
7 Wire coil attachment and brake
8 Wire coil
Description
38