Operating Mode; Manual Mode; Automatic Mode - Espa MULTIPOOL PLUS Manual De Instrucciones

I N S T R U C T I O N M A N U A L
3.4 - Start function
The first time the circuit is powered up, it is recommended that
the reset button is pressed; this starts up the circuit afresh, dele-
ting all programmes.
Press the Select and OK buttons simultaneously and move on
the next screen.
The pump is stopped

3.5 - Operating mode

One of the menus is chosen with the Select button, while the OK
button validates the choice for entering it. The menus available
are:
• Manual operation
• Automatic operation
• Current time and date setting
• Programming of automatic programmes

3.5.1 - Manual mode

First select the manual menu by activating the line above the
word MANUAL. The pump is run or stopped using the OK but-
ton.
Pump
stopped

3.5.2 - Automatic mode

In automatic mode the pump starts and stops under the control
of one of the 8 programmes.
To set automatic mode, follow the steps shown below:
Press Select until the line
above
AUTO flashes
SEL SEL
OK button confirms
AUTO mode
OK
Pump stopped
Flashling
OFF
Pump
running
Manual
operation
flashing
Automatic
operation
3.5.3 - Setting current date and time
Press Select until the LED
beside the clock simbol flashes
SEL SEL
Set the minutes
SEL SEL
Flashing
Set the times
SEL SEL
Flashing
Select the day of the
week
SEL SEL
Once the day of the week
has been confirmed, exit from
the programming menu is automatic
If no key is pressed for more than 10 seconds, exit from the
menu is automatic and no changes are saved.
3.5.4 - Programming the automatic programmes
There are eight programmes, each with its start and stop time;
the day of the week it is to operate can also be set, so that it
could be one day, two days or every day, for example. A pro-
gramme with no day set is a deactivated programme.
As an example, programme 1 will be programmed to start at 8:30
and end at 12:30 on Mondays, Wednesdays and Saturdays.
Select the programming
menu
SEL SEL
Select the programme nº
SEL SEL
Prog. nº flashing
Set the start minutes
SEL SEL
6
Flashing
Confirm hour
programming
the minutes
Flashing
Confirm date and
exit the menu
Fr
Confirm the
Flashing
programing
Informs that it is start time
Flashing
Confirm
the minutes
GB
menu
OK
Confirm
OK
Confirm
the times
OK
OK
menu
OK
Confirm the
programme
nº
OK
OK