Sevylor MINNESOTA Manual De Utilización página 10

Water will enter between the outer hull and inside chambers, this is O.K; however, whenever you take this item
out of the water and deflate it, allow for it to air out and dry, neither the skin/hull or the inside chambers will
suffer from water damage, but stagnant water could cause mildew and foul odor.
HOW TO REPAIR SMALL PUNCTURES
You can repair small punctures with the included repair kit (Note: Glue not included in USA). Please note that in order for
the repair to be successful, the humidity level should be less than 60 %, temperature between 65° F/77° F or 18° C/25° C.
Avoid carrying out repairs in the rain or in direct sunlight.
To access the chambers, open the appropriate zip fastener. The zip fastener for the main chamber and the safety
chamber is located inside the kayak. The zip fastener for access to the floor chamber is located on the bottom at the bow
and the stern.
Check that the tube is fully deflated and lies flat.
1. Draw the shape of the patch exactly where it will be applied, cut a round patch at least 2" / 5 cm larger than the
cut/damaged area.
2. Clean the damaged area and the corresponding side of the patch with a grease remover of the alcohol type and allow
for it to dry for 5 minutes.
3. Apply 3 thin layers of glue on both the patch and the damaged area, allow for it to dry for 5 minutes between layers
until the glue feels tacky.
4. When the third layer of glue is dry, apply the patch without pressing and adjust the positioning if required, press the air
bubbles which may have formed under the patch by smoothing the patch with a round object such as a spoon, do this
procedure by starting in the center of the patch towards the outside, clean the excess glue with a solvent. Drying: 12
hours.
E  Perform all of your repairs in a well-ventilated area.
 Avoid inhaling glue vapors or swallowing.
N
G
L
N.B: The repairs on the weldings cannot not be glued. In this case, the chamber needs to be replaced.
I
S
H WARRANTY
- The product is covered by a total parts and labor warranty for a period of 2 (two) years from its purchase date.
- The warranty applies to products that do not conform to the order or that are defective.
- Within the guarantee period, the product shall be either repaired, replaced or reimbursed - in full or in part. Liability to
Buyer under a claim shall in no event exceed the price of the product.
- The warranty is null and void and does not apply should the damage arise from (i) abuse of the products (ii) failure to
operate and maintain the products in accordance with the instructions of use (iii) repair, service, alteration or
modification of the product by unauthorized third parties (iv) original parts are not used. It does not cover perforations or
abrasion resulting from normal use.
- The warranty is excluded in case of professional use.
- Proof of the purchase date (ie. invoice, till receipt) and claim report are required to obtain a free warranty service.
- Service under the guarantee does not affect the expiry date of the warranty.
- All other claims including for damages resulting from this warranty are excluded unless ADG's liability is legally
mandatory.
- This guarantee in no way affects a Buyer's statutory rights.
- In the event of difficulty, please contact the Local Customer Service in your country. List of contacts is available in this
leaflet.
WARNING!
WARNING!
 Avoid contact with the skin or the eyes.
 Keep all repair materials (glue, solvents, etc.) away
from children's reach.
10