3M PROTECTA AE521 Manual De Instrucciones página 23

6.0 MAINTENANCE, SERVICE, AND STORAGE
;
Do not clean and disinfect the
methods may have adverse effects on the
6.1 CLEANING: Cleaning procedures for Energy Absorbing Lanyard are as follows:
• Periodically clean the exterior of the Lanyard using water and a mild soap solution. Water temperature must not
exceed 40 °C (104 °F). Position the Lanyard so excess water can drain out. Do not dry-clean. Do not iron. Clean
labels as required.
• Clean the Web Lifeline with water and mild soap solution. Rinse and thoroughly air dry. Do not force dry with
heat. The lifeline should be dry before allowing it to retract into the housing. An excessive buildup of dirt, paint,
etc. may prevent the lifeline from fully retracting back into the housing causing a potential free fall hazard.
;
Use a bleach-free detergent when cleaning the Lanyards. Fabric softener or dryer sheets SHOULD NOT be
used when cleaning and drying the Lanyards
6.2 SERVICE: Lanyards are not repairable. If the Lanyard has been subjected to any damage or fall force, or inspection
reveals an unsafe or defective condition, remove the Lanyard from service and discard.
6.3 STORAGE/TRANSPORT: Store and transport Lanyards in a cool, dry, clean environment out of direct sunlight.
Avoid areas where chemical vapors may exist. Thoroughly inspect the Lanyard after any period of extended storage.
7.0 LABELS
Figure 19 illustrates labels on the the Energy Absorbing Lanyards and their locations. All labels must be present on the
Lanyard. Information on each label is as follows:
19
Figure Reference:
1
2
3
4
5
6
7
8
9
10
11
12
13
14
Lanyards
by any method other than described in the following "Cleaning Instructions". Other
Lanyards
Description:
Model number
Serial number
Batch number
Address of the Manufacturer
Read these instructions before using the Lanyard
European standard
CE Marking of European Conformity
Number of Notified body carrying out Conformity to type
Length
Month of manufacture
Year of manufacture
Web Address of the Manufacturer
Minimum Fall Clearance
Capacity
or user.
23