Harbor Breeze 00598 Manual De Instrucciones página 4

ASSEMBLY INSTRUCTIONS
1. Determine mounting method.
Downrod Mount (standard or angled ceiling)
Important: lf angle mounting, check to make sure the
ceiling angle is not steeper than 20°.
2. Install mounting bracket (A) to outlet box (not included
by sliding mounting bracket (A) over the two outlet box
screws (not included). Securely tighten two outlet box
screws.
Important: If angle mounting, make sure open end of
mounting bracket (A) is installed facing the higher part
of the ceiling.
3. Remove preassembled pin and clip from downrod (E).
Save for later use.
1
2
Outlet box
3
E
Clip
Pin
6
ASSEMBLY INSTRUCTIONS
4a. STANDARD DOWNROD INSTALLATION:
Insert downrod (E) through canopy (B), canopy
cover (C), and yoke cover (D). Thread wires from fan
motor assembly through downrod (E).
4b. EXTENDED DOWNROD INSTALLATION:
If you are installing the fan with a longer downrod
(sold separately), insert it through the canopy (B),
canopy cover (C) and yoke cover (D). Then, thread
lead wire (N) through the downrod and connect the
MALE plug from the top of motor assembly (H) to the
FEMALE plug from the lead wire (N).
NOTE: The male plug of the lead wire (N) should
extend out of the other end of the downrod.
NOTE: The remainder of the instructions will
reference downrod assembly (D), but note all of
the instructions are applicable even if an accessory
A
downrod was used.
5. Loosen preassembled set screws from yoke on fan
motor assembly (H). Slip downrod (E) into housing
yoke, aligning holes on both parts. Insert previously
removed pin through holes on yoke and downrod (E),
then insert previously removed clip into pin until it
snaps into place. Tighten set screws.
4a
E
C
D
4b
C
D
Female Plug
Male Plug
H
5
E
Yoke
Clip
Pin
7
B
B
Set screw
H