Descargar Imprimir esta página

AZOL GAS MINI Serie Manual De Instrucciones página 22

Resortes de gas

Publicidad

XXII
www.azolgas.com
MOUNTING GUIDELINES
DROP-IN
ENG DROP-IN MOUNTING
DEU EINBAU IN KAVERNE
FRA MONTAGE DANS POCHE
ITA
MONTAGGIO NELLA SEDE
ESP MONTAJE EN CAJERA
POR FIXAÇÃO NO ALOJAMENTO
ØB
Min.
80%L
When the gas springs are installed into a bored pocket, the bored pocket diameter should not exceed 1mm larger
than the gas spring body diameter. And the bore pocket depth must be minimum 80% of L.
Screws on the base should be always used for strokes lengths > 25 mm.
The base should be supported at all the times. A flat surface against the base is always required.
Do not mount a gas spring in a pocket upside down.
Innadecuate pockets (with higher diameter or shorter length) could cause structural damages and reduce the life
expectancy of the gas springs.
Service in Motion
S<25
L
+1,0
ØB
+0,5
azolgas@azolgas.com
!
Protect the gas springs from solid or liquid
contaminants.
Provide adequate drainage in gas springs pockets.
Tel. +34 945290010
!
S>25
!

Publicidad

loading