Consecutive Settings - Mitsubishi Heavy Industries SC-SL2NA-E Manual Del Propietário

4. Press the RESET button.
The GROUP No. display section becomes blank.
Example: " 00"
5. Press the SELECT (
The selected unit number fl ashes.
Example: " 05"
6. Press the SET button.
The UNIT No. lights up and after 2 seconds, fl ashes.
With this, the display unit number is registered as not being managed.
When you set a registered unit number as not being managed, the number of managed units decreases.
[Changing an indoor unit number]
To change the indoor unit number and continue with setting another unit to not be managed, after Step 6, repeat
Steps 7 and 8.
7. Press the SELECT (
8. Press the SET button.
Note
• To end the setting or to cancel settings being made, press the MENU button.
• If you press a GROUP No. button in 3 to 8, you can make a group setting.
• You can also make these settings from partway through group settings (Page 7).
• It is possible to set units with consecutive addresses all at once.

Consecutive Settings

To set multiple indoor units with consecutive addresses at one time, execute "Group Settings" Step 5 or "One
Setting" Step 5 or "Units not to Be Managed" Step 6, then set the following.
1. Hold down the SET button (for at least one second).
Consecutive settings start from the indoor unit number that has been set. The UNIT No. display section be-
comes "--".
The consecutive setting starting unit number is displayed and the end unit is displayed fl ashing in the column
at the bottom.
or ) button to set the indoor unit number.
or ) button to set the indoor unit number.
2 1, 3
Page 11
– 11 –
Page 8 Step 3