How To Set Demand Units - Mitsubishi Heavy Industries SC-SL2NA-E Manual Del Propietário

How to Set Demand Units

Demand operation is not available in this central control.
When a demand controller is connected to this central control, demand operation becomes possible. For indoor
units for which demand is set, signals from the external demand controller change the operation mode to FAN
and change the CENTER / REMOTE setting to
1. Press the ALL / GROUP / ONE button and select
To set all the managed units, select
To set one or more groups, select
To select all the groups, select "88".
To set one or more individual units, select
number.
2. Press the DEMAND SET button.
The light up.
To set another group or individual indoor unit, repeat Steps 1 and 2.
Note
• When the signals are cancelled, the operation mode returns to that before demand operation started.
• To cancel the demand setting, in the state in Step 1, press the DEMAND SET button again. Demand operation is
disabled.
• During demand input, the
• During demand input, the CENTER / REMOTE and MODE settings can not be changed.
• For some jumper line settings, the CENTER / REMOTE setting does not change to
on jumper line settings, consult your dealer.
• During demand input, the demand unit settings can not be changed.
❚
By setting control select switch SW6 to OFF, it is possible to prohibit operation with the local remote
controller by signals from the outside for indoor units for which demand is set.
When the signals from the outside are cancelled, the CENTER / REMOTE setting returns to its original state.
But the operation mode remains and does not change to
For more information on setting the control select switch, consult your dealer.
.
1 2
.
, then press the SELECT (
, then press the SELECT (
fl ashes.
REMOTE
CENTER CENTER
External signal
input
– 29 –
, , or .
or ) button to set the group number.
or
.
REMOTE
CENTER
External signal
cancelled
) button to set the unit
. For more information