How To Set Programs; How To Set "Run At On Time, Stop At Off Time - Mitsubishi Heavy Industries SC-SL2NA-E Manual Del Propietário

Note
• This operation is only possible for indoor units whose CENTER / REMOTE setting is "CENTER" or "CENTER
and REMOTE". This operation is disabled on indoor units set to REMOTE.
• After central control operation, it may take a few minutes until the indoor unit settings change.
For automatic operation, the indoor units automatically switch between "Cool" ⇔ "Heat" according to the differ-
•
ence between the set temperature and the room temperature to hold the room temperature constant. (This only
applies to heat recovery systems.)
• When you press the TEMP button and raise or lower the set temperature, the units may stop.
This is because the temperature adjuster has worked, not because anything is wrong.
• For Dry operation, the fan speed automatically cycles between Weak and Stop according to the room tempera-
ture.
• For indoor units with different operation modes, with outdoor units not capable of mixed cooling and warming
operation, the "MODE" display fl ashes.
• Some operations can not be set for some indoor unit models. Refer to the user's manual for the indoor unit.

How to Set Programs

These settings are made group by group.
For each day of the week, up to four on / off times, run / stop, and set temperature can be set.
The four types of patterns on the below can be set for one program.
1. RUN at On time, STOP at Off time
2. RUN and TEMP (temperature setting) at On time
3. RUN only at On time
4. STOP only at Off time

1. How to Set "RUN at On time, STOP at Off time"

1. Press the MENU button and select
Each time you press this button, the display moves to the next step in the sequence in the diagram below.
The
2. Press the SET button.
2, 4, 6, 8, 10, 12, 14, 16
1
3, 5, 7, 9, 11, 13, 15
3, 9, 11, 13, 15
Off
fl ashes.
.
– 19 –