Mitsubishi Heavy Industries SC-SL2NA-E Manual Del Propietário página 9

1. Press the MENU button and select
Each time you press this button, the display moves to the next step in the sequence in the diagram below.
The fl ashes.
2. Press the SET button.
The lights up and "01-00" fl ashes.
3. Press the GROUP No. button for the group to be set.
The selected group number fl ashes.
Example: 02-00
4. Press the SELECT (
The selected unit number fl ashes.
Example: 02-05
Steps 3 and 4 can be in either order.
5. Press the SET button.
The group number and unit number light up and after 2 seconds, fl ash.
With this, the display unit number is registered as the display group number.
If you register a unit number that had not been registered before this, the number of managed units increases.
<Changing an indoor unit number>
To change an indoor unit number within the same group, repeat Steps 4 and 5.
<Changing the group number>
To change the group number and to make group settings, repeat Steps 3 to 5.
Note
• To end the setting or to cancel settings being made, press the MENU button.
• It is possible to set units with consecutive addresses all at once.
Off
or ) button to set the indoor unit number.
.
Page 11
– 8 –