Simon, Evers & Co K 968 795 Instrucciones De Servicio página 57

7. NEVER TRANSPORT UNSTABLE OR LOOSELY STACKED OBJECTS.
8. NEVER OVERLOAD THE UNIT.
9. NEVER LOAD THE PLATFORM ON ONE SIDE OR MAKE IT TOP-HEAVY
OR PLACE LOADS THAT STICK OUT OVER THE EDGE OF THE
PLATFORM.
10. THE CAPACITY OF THE UNIT ASSUMES THAT THE LOAD WILL BE
PERFECTLY BALANCED FOR TRANSPORT WITH THE CENTRE OF
GRAVITY IN THE CENTRE OF THE FORKS AT THE FRONT.
11. ENSURE THAT THE LENGTH OF THE FORKS IS THE SAME AS THE
LENGTH OF THE PALLET.
12. LOWER THE FORKS AS FAR AS POSSIBLE WHEN THE UNIT IS NOT IN
USE.
II. Commissioning
1.) In order to lift the lifting forks, please push the lever (2) downwards and pump by moving
the drawbar up and down.
2.) In the centre (neutral) position of the lever (2) you can move the platform floor truck by
means of the drawbar without lifting the lifting forks.
3.) If you want to lower the lifting forks, please pull the lever (2) in an upwards direction.
III. Load Diagram
Lever (2)