Important; Downrod-Style Fan Mounting - Harbor Breeze CHA52BNK5LR Manual

INITIAL INSTALLATION
Secure mounting bracket (C) to outlet box (not
5.
included) using screws, spring washers and flat
washers provided with the outlet box.
*NOTE: It is very important you use the proper
hardware when installing the mounting bracket (C)
as this will support the fan.
IMPORTANT: If using the angle mount, make
sure open end of mounting bracket (C) is installed
facing the higher point of the ceiling, and ensure
the ceiling angle is not steeper than 19°.
6.
Remove preassembled motor blocks from
underside of motor housing (D). Discard the
motor blocks.
Remove motor screws/washers (R) from
underside of motor housing (D), and save for
blade arm (L) attachment later on.
For DOWNROD-STYLE FAN MOUNTING,
proceed to step 1 below.
For CLOSEMOUNT-STYLE FAN MOUNTING,
skip to page 9.

DOWNROD-STYLE FAN MOUNTING

1a.
Remove pin (N) and clip (O) from downrod (A).
1b.
Partially loosen preassembled set screws and
nuts in yoke at top of motor housing (D).
5
STANDARD
MOUNT
C
6
Motor
Block
1a
O
D
7
ANGLE
MOUNT
C
Open End
1b
A
N
Set Screw
& Nut
Yoke
R
D