Cybex Platinum ATON Q Manual Del Propietário página 36

INSTALLING INFANT CARRIER WITH A LAP/SHOULDER BELT (ALTERNATE)
6. Check the recline angle. Adjust the seat angle until the red Level
Line on the Infant Carrier is level with the ground. A tightly rolled
towel or pool noodle may be placed under the Infant Carrier,
near the vehicle seat back to adjust the angle. See page 39.
The Aton Q is allowed to touch the vehicle seat(s) in front of it, as long
the recline angle of the Aton Q is not affected.
7. Grab the Infant Carrier at the Belt Guides and pull
from side to side and front to back to make sure it
is installed correctly. The Infant Carrier should not
move more than 1 inch (2,5 cm) in any direction.
If the Infant Carrier moves too much, tighten the vehicle belts more
and recheck. You may try a different vehicle seat or installation
method, or both.
8. If the Infant Carrier is next to a vehicle door or panel,
extend the adjacent L.S.P. device. See page 38.
ALWAYS have the handle locked in the upright DRIVE/
CARRY position while using this child restraint in a
vehicle.
NEVER INSTALL the Infant Carrier with both the Lap
and Shoulder Belts routed underneath BOTH Belt
Guides.
35
All manuals and user guides at all-guides.com

FRONT OF VEHICLE
6
LINE MUST BE LEVEL WITH GROUND
WHEN INSTALLED WITHOUT BASE
FRONT OF VEHICLE
LINE MUST BE LEVEL WITH GROUND
WHEN INSTALLED WITHOUT BASE
8