Care And Cleaning; Removing The Seat Cover - Cybex Platinum ATON Q Manual Del Propietário

REMOVING THE SEAT COVER

The seat cover is designed to be very taut and to fit exactly
inside the Infant Carrier. Please pay close attention before and
during the removal of the cover, to help remember how to put
it back on.
First, unbuckle the Harness and Chest Clip
HEADREST COVER
1. Remove Shoulder and Buckle Pads
2. Open Velcro at both sides of headrest cover
3. Carefully remove the cover from the headrest
SEAT COVER
4. Open buttons at both sides of seat cover
5. Detach snaps on both sides of seat cover (near handle)
6. Pull Canopy out of the shell canal
7. Fully extend canopy
8. Detach canopy snaps from back of shell
9. Detach three snaps from seat cover on back of shell
10. Remove seat cover from the Top
11. Carefully remove seat cover around the belt Guides
12. Pull the buckle through the seat cover
13. Remove seat cover
All manuals and user guides at all-guides.com

CARE AND CLEANING

INSTALLING THE SEAT COVER
Reverse the removal instructions to reinstall the Seat Cover. Start
at the top of the seat and work your way down to the Belt Guides
and foot area.
Pay close attention to reinserting the edge of the Seat Cover into
the tight spaces around the Belt Guides, as well as the foot end of
the seat.
The integrated Harness System cannot be removed
from the seat. NEVER remove or attempt to remove
parts of the Harness System.
DO NOT damage, remove or dispose of any EPS foam.
NEVER use Infant Carrier without a properly installed
Seat Cover.
40