Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
8
Travel acquisition
For the system to function correctly, the door travel must be acquired by the control.
Before starting:
1. Move the door into the fully closed position. The control unit determines the open and close travel values
electronically. If any difference found between the two travel values, the acquisition procedure fails.
2. Press TEST
3. Check that the limit switches are set correctly. Check the door closed limit switch in particular.
ACQUISITION PROCEDURE:
Esempio
TEST
CHIUSA
PROG
PROG
AP P-
AU to
x4 s
1 click
• Press and hold PROG for 4 seconds.
• Press PROG again.
• The door starts opening at low speed.
•
• The door closes until it reaches the door closed stop.
If the acquisition procedure is completed successfully, the display enters the command and safety device state display
mode.
If the following error messages are shown on the display, repeat the acquisition procedure:
•
: acquisition error
•
: travel length error
•
TEST
14
No
Yes
Sì
TEST
FC
APERTURA
APERTA
is shown on the display.
is shown on the display.
See safety input (Chap. 12) and Alarm and fault (Chap. 13)
Vedi Segnalazioni degli ingressi (Cap. 12) e Allarmi (Cap. 13)
AU to
CHIUSURA CHIUSA
,
,
).
Yes
Sì
39
Publicidad
Tabla de contenido
