Using The Softkeys; Navigating Between Menus; Navigating Within A Menu - Mettler Toledo SevenGo pro Instrucciones De Montaje

2. ppm
3. mg/L

4.4 Using the softkeys

The meter has three softkeys. The functions assigned to them change during operation depending on the appli-
cation. The assignment is shown on the bottom line of the screen.
In the measurement screen, the three softkeys are assigned as follows:
Menu
Access meter settings
The other softkey functions are:
Delete

4.5 Navigating between menus

The meter display consists of a measurement frame, softkeys, areas for status icons and underlying menu
areas.
To access the menu areas and to navigate between them, use various softkeys (see "Using the softkeys").
1 Press Menu.
The Setup menu appears and Sample ID is highlighted.
2 Press to highlight the Setup tab.
3 Press to highlight the pH/Ion tab (only SG98).
4 Press to highlight the DO tab.
5 Press MODE/EXIT to return to the measurement screen.

4.6 Navigating within a menu

This example is based on the Setup menu, but the procedure applies to the other menus as well.
Press Menu.
The Setup menu appears and Sample ID is highlighted.
Press as often as needed to navigate to a menu item.
Press Select to move deeper in the menu for the chosen operation.
Continue navigating with
Press MODE/EXIT to go back to the previous menu.
— or —
Press READ to return to the measurement screen directly.
SevenGo (Duo) pro™/OptiOx™
Save an endpointed measurement
Move one position to the right
Move one position to the left
Scroll up in the menu
Scroll down in the menu
Increase value
Decrease value
Scroll to next data set in memory
Delete letters or numbers on
alphanumeric keypad
Delete selected data
, or Select until the final destination is reached within the menu.
Store
Access data menu
Edit Edit table or value
End calibration
End
Yes Confirm
Reject
No
Review Review selected data
Save Save data, setting or value
Select the highlighted function or
Select
setting
Start Begin the reference measurement
Trans Transfer selected data
Operating the pH/ORP/Ion/DO meter SG98 and DO meter SG9​ ​ 13
Data