Calibration Data - Mettler Toledo SevenGo pro Instrucciones De Montaje

Measurement mode
1 Select a measurement mode from list and press Review. The meter finds all stored measurements of the
selected measurement mode.
2 Scroll through the measurement data of the selected measurement mode.
Delete
All or partially stored measurement data can be deleted by filtering the measurement data. The filter works as
described above in "Review".
Note
Deletion is protected by a PIN. Upon delivery, the PIN is set to 000000. Change the PIN code to prevent
unauthorized access.

7.3 Calibration data

Calibration data can be reviewed and deleted. Up to 5 calibrations per sensor ID are stored in the memory.
Review
1 Select between the sensor types: pH, ion or DO (only SG98).
2 Press Review.
A list of calibrated sensor IDs appears.
3 Select a sensor ID from the list and press Review.
4 Press and
— or —
Press and hold CAL for 3 seconds in the single channel measurement screen.
The current calibration data is displayed.
Delete
1 Select between the sensor types: pH, ion or DO (only SG98).
2 Press Delete.
A list of sensor IDs appears.
3 Select a sensor ID from the list and press Delete.
4 Press Yes when the message "This will delete all your selected data. Please confirm." appears
— or —
Press No to cancel and exit.
After deletion, the sensor ID disappears from the list in the sensor ID menu.
Note
An active sensor ID cannot be deleted.
This menu is protected by a deletion PIN code. Upon delivery, the PIN code is set to 000000. Change the
PIN code to prevent unauthorized access.
7.4 ISM data
SevenGo Duo pro™ SG98 and SevenGo pro™ SG9 incorporate Intelligent Sensor Management (ISM
technology. This ingenious functionality provides extra security, safety and eliminates mistakes. The most
important features are:
Extra security!
After connecting the ISM
number are transferred from the sensor chip to the meter.
After calibration of the ISM
chip. The most recent data is always stored where it should be – on the sensor chip!
Extra safety!
After connecting the ISM
reviewed to see the development of the sensor over time. This information provides an indication if the sensor
should be cleaned or renewed.
SevenGo (Duo) pro™/OptiOx™
to navigate between the previous or next calibration data sets.
®
sensor, the sensor is automatically recognized and the sensor ID and serial
®
sensor, the calibration data is automatically stored from the meter to the sensor
®
sensor, the five most recent calibrations are transferred to the meter. These can be
®
)
Data management​ ​ 27