Publicidad
Idiomas disponibles
Idiomas disponibles
1
AA
BB
Mark the general area where the mounting bracket (AA) will be located. Using a small drill or nail, make two small pilot holes at the
marked locations. Align the mounting brackets (AA) and drive screws (BB) into place. NOTE: Ensure mounting location is within 5ft. of
an electrical outlet.
Lift the fixture toward the mounting brackets (AA) while aligning the top of the fixture channel with both clips. Apply upward pressure
until channel snaps into place and seats into both brackets.Plug into outlet.
OPTIONAL: INSTALLING ADDITIONAL LIGHTS
Once installation is
complete, plug each
additional fixture into
the fixture ahead of it.
A total of 240W
maximum.
ON/OFF DIMMING BUTTON
Press this
button to
change
brightness
Press once:
Turn fixture ON and OFF
Press and hold:
Adjust 0-100% brightness
CARE AND MAINTENANCE: Periodically clean the fixture and diffuser using a mild, non-abrasive cleaner and soft cloth. When cleaning the fixture, make sure the power is turned off. Do
not spray cleaner directly onto any part of the fixture or LEDs.
Good Earth Lighting
- 6 YEAR LIMITED WARRANTY: The manufacturer warrants this lighting fixture to be free from defects in materials and workmanship for a period of (6) years
®
from the date of original purchase by the consumer. The fixture is not warrantied for use in a commercial or retail application. The warranty is limited to use in a residential environment.
We will repair or replace (at our option) the unit in the original color and style if available, or in a similar color and style if the original item has been discontinued, without charge. Defective
units must be properly packed and returned to the manufacturer with a letter of explanation and your original purchase receipt showing date of purchase. Call 1-800-291-8838 to obtain a
return authorization number and an address where to ship your defective product. Note: C.O.D. shipments will NOT be accepted. The liability of the manufacturer is in any case limited to
replacement of the defective light fixture product. The manufacturer will not be liable for any other loss, damage, labor costs or injury which is caused by the product. This limitation upon
the liability of the manufacturer includes any loss, damage, labor costs or injury which is (I) to person or property or otherwise; (II) incidental or consequential in nature; (III) based upon
theories of warranty, contract, negligence, strict liability, tort, or otherwise; or (IV) directly, or indirectly related to the sale, use, or repair of the product. This warranty gives you specific
rights, and you may also have other rights which vary from state to state.
FCC STATEMENT: This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that the interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 1)
Reorient or relocate the receiving antenna. 2) Increase the separation between the equipment and receiver. 3) Connect the equipment into an outlet on a circuit different from that of the receiver. 4) Consult the
dealer or an experienced radio/TV technician for help.
FCC responsible party name : Good Earth Lighting, Inc. Address: 1400 E Business Center Drive, STE 108, Mount Prospect IL 60056, USA
Telephone number: 1-800-291-8838
PROBLEM
1. Light does not come on.
2. Fuse blows or circuit breaker trips when
light is turned on.
REPLACEMENT PARTS LIST
Need Help?
Good Earth Lighting
1400 East Business Center Drive, Ste. 108 Mount Prospect, IL 60056
®
Good Earth Lighting
is a registered trademark of Good Earth Lighting, Inc.
®
© 2021 Good Earth Lighting, Inc.
MOUNTING BRACKET INSTALLATION
2
TROUBLESHOOTING GUIDE
POSSIBLE CAUSE
1. Power/ light switch is off.
3. Bad switch.
1. Discontinue use.
ZH-UC1270F00-WHG
Hardware Kit:
Please visit our website at: https://goodearthlighting.com/contact-us or call the
Customer Care Center 1-800-291-8838, 8:30 a.m.-5 p.m., CST, Monday-Friday.
OPTIONAL: USB PORTS
This fixture can be used to charge
various USB related devises.
(USB cords not included)
USB Port: 1 AMP each port
5 LIGHT SETTINGS BUTTON
Press this
button to
change the
color
temperature
2700K Soft White
3000K Bright White
4000K Cool White
5000K Daylight
6500K Daylight Deluxe
CORRECTIVE ACTION
1. Verify power supply and light switch are on.
3. Test or replace switch.
1. Call customer service (1-800-291-8838).
2
Printed in Vietnam
Publicidad
