Operating Environment; Installation Instructions - inbody 570 Manual De Instrucciones

B. Operating Environment
Please make sure that the environment is adequate for the InBody570 installation. This equipment is designed
for indoor use. If installing outdoors, the following requirements must be fulfilled.
C. Installation Instructions
1. Open the packing box of the InBody570 and remove the packing pads. Then take the InBody570 out of the box.
Polyethylene foam cover
Packing pads
UTION NOTE
DANGER
참 고 주 의
If you have any problems installing your InBody570, please contact InBody for assistance.
•
Do not transport the equipment by holding the screen portion or the joints of the hand electrodes.
•
Keep the packing materials provided for repacking the equipment in the future. Other wastes should be
•
disposed of according to relevant laws and regulations.
2. After completely raising the upper part of the InBody570, remove the polyethylene foam cover.
* Please refer to the following illustrations to properly transport the equipment.
UTION NOTE DANGER
참 고 주 의
Using the InBody570 on carpet may cause static electricity, which could damage the equipment. If installing
•
the InBody570 on carpet is unavoidable, please use an antistatic mat.
Install the InBody570 on a leveled, non-vibrating surface. Installing the equipment on an uneven surface may
•
cause the examinee to fall down. Test results may also be inaccurate.
Never clean the hand and foot electrodes with liquid spray or detergent directly. The equipment may corrode
•
and/or malfunction if the liquid or detergent leaks inside. Use the InBody Tissue when cleaning the InBody570.
Temperature range
Relative humidity
Atmospheric pressure
Caution
참 조 주 의
재포장
Caution
참 조 주 의
10 ~ 40°C (50 ~ 104°F)
30 ~ 75% RH
70 ~ 106kPa
Joint frame
7 7
EN