Costway SP37674 Manual Del Usuario página 8

4.Installation
Assembly instructions: Before assembling, please check whether the accessories are
complete according to the parts drawing. The gross weight of this product is 28kg, the
net weight is 25kg, the base area is 64cm*100cm, and the height of the vehicle after
installation is 120cm. It is recommended that two or more persons cooperate with the
installation in an open area.
(1)Take the front foot tube out and put it into the strip hole at the rear of the frame, put a
flat washer Ф8 and a spring washer Ф8 on the bolts in turn, then put on the cover nut,
and lock it with our special open-end wrench. (The installation of the rear leg tube is the
same as above.)
(Note: After the front and rear legs are installed, the product may have three feet on the
ground. At this time, the height of the black foot cover on the leg can be adjusted to
balance the product)
(2)Take out the pedals, you will find the pedals are marked with "L" and "R" pattern.
Take out the pedal marked "R", remove the nut on the pedal, and insert it into the
threaded hole of the crank on the right side, turn it clockwise until it stops, and then use
our special open-end wrench to lock it. Finally screw the nut a little bit firmly, and then
tighten the nut with our open-end wrench. Take out the "L" pedal, remove the nut, insert
it into the threaded hole of the left crank, and turn it counterclockwise until it stops.
Then use our special open-end wrench to lock it, and finally screw the nut in a little bit
again. Tighten the nut with our open-end wrench.
(Note: The crank is also marked with "L" and "R" pattern corresponding to the
markings on the pedals. If it is installed incorrectly, it may cause the slippery wire of the
crank to damage the product. And the pedals must be locked, otherwise the pedals may
fall off after a long time. And the nut is also distinguished by left and right. The "L"
pedal corresponds to the inner ring with a blue non-slip nut, and the "R" pedal
corresponds to the nut with white non-slip inner ring).
Note: The pedals in the schematic diagram may be different from the actual product, the
picture is for illustrative purposes.
07