Table Saw Angle Cutting; On/Off Switch; Use As A Mitre Saw; Important - HOLZMANN MASCHINEN TK305 Manual De Intrucciones

17.3.1 Table saw angle cutting

1. Install and position the "table orientation plate
groupware".
2. According to your actual required of cutting
angle to adjust the "table orientation plate
groupware" location.
a. Put the cutting objects on the table working
face.
b. Select the cutting angle data:
Select and cut objects angle between: -
30°～90°～30°. Then screw up the "cutting &
position angle knob" with your hand.
3. Hold the "Safety plush stick" and push the
cutting object forward until it to sever.

ON/OFF SWITCH

The "ON/OFF SWITCH" button is located on the right side of the handle.
Press the "ON" button to start the machine.
Press the "OFF" button to stop the machine.

17.4 Use as a mitre saw

Fixing knob 1 loosen up (6-1)
ATTENTION !
press the operating handle
light down
HOLZMANN MASCHINEN GmbH
Diagram-6-4
Fixing knob 2 loosen up (6-2)
Diagram-6-4
1
so this allows the locking
bolt (1) easily pull out of
the hole and the crosscut saw
swings upward. (6-4)
www.holzmann-maschinen.at
OPERATION
Pull worktable -with locking
plate- all the way up and
back positioning with 1 and 2
clamp top. (6-3)
Diagram-6-5
Locking bolt completely
pulled out of locking plate.
(6-5)
IMPORTANT: worktable must
be clamped on the top !
36
TK 305