HOLZMANN MASCHINEN TK305 Manual De Intrucciones página 37

Remove the "lower blade
guard".
Insert the lower blade guard
after the end of the work.
1. Install the extend pole
Hold the "extend pole" with your hand. Then insert it to
the hole of the base side until it to go on; when the pole
and hole are in a straight line.
As same as the other side.
2. Use the clamp groupware to work.
Put the board on the "circular pan";
a) Reference "location ruler" to select a cutting length, then
screw up the "clamp groupware" knob until it to clamp
the board.
3. Use the mitre saw
a) Hold the handle and trigger switch;
b) Press the "mitre drop & lock button" down;
c) Push down the mitre head to cut the board.
d) If the cutting board too short. So you must use the
"safety push stick".
e) Cutting the board until it to server.
f) Loosen the trigger of the mitre, until it rise slowly.
g) Release your hand
HOLZMANN MASCHINEN GmbH
Install the clamp groupware:
a) Hold the "clamp groupware" pole, insert it to the hole in
the "location plate" left side.
b) fix with the "butterfly screw" 1
www.holzmann-maschinen.at
OPERATION
37
TK 305